Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Measuring tape
Pencil
Masking tape
Scissors
No. 2 Phillips screwdriver
Drill
Parts Supplied (not shown to scale)
M5 x40 mm bolts (4)
Template
* Depending on cabinet shelf depth and/or cabinet trim overhang
length, bolts longer than those provided 40 mm) may be
required.
INSTALLATION REQUIREMENTS
3/8" (9 mm) drill bit
3/8" (9 mm) wood bit or metal
hole cutter (if installing under a
metal cabinet)
Covering or microwave
oven carton
Washers
(4)
Location Requirements
Caution: This microwave oven is intended for installation over a countertop.
Do not install this microwave oven over any heat source, such as a range
or cooktop.
Check the opening where the microwave oven will be installed.
The location must provide:
Minimum cabinet depth of 14 4/7" (370 mm).
Cabinet lower shelf thickness of 5/8''- 11/6''(16mm-30mm).
Support for weight of at least 48.5 lbs (22kg), which includes the
combined weight of the microwave oven (29.7 lbs/13.5 kg) and
the normal cabinet contents.
Grounded electrical outlet inside upper cabinet. See
"Electrical Requirements" section.
Product Dimensions
EN-2