tibelec DT930 Manual De Uso página 15

1. Connect the black probe to terminal COM and the red probe to terminal VΩ
2. Set the function switch to the CAP, nF appears on the screen
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VΩ
2. Set the function switch to the CAP Hz%, Hz appears on the screen
3. Connect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
1. Connect the black probe to terminal COM and the red probe to terminal VΩ
2. set the function switch to the
3. press the RANGE key to bring up the symbol
4. Sonnect the test plungers to the circuit and read the value displayed on screen once it has stabilised.
5. Reverse the probe polarity by switching probe position. Note this reading.
6. The diode or junction can be evaluated as follows :
a. If one reading shows a value and the other reading shows OL, the diode is good
b. If both readings show OL, the device is open
c. If both readings are very small or 0, the device is shorted.
The value indicated on the during the diode check is the forward voltage.
1. Connect the black probe to terminal COM and the red probe to terminal
2. Set the function switch to the
3. Press the RANGE key to bring up the symbol
4. Connect the test plungers to the circuit, if the resistance is less than approximately 100Ω, the audible
signal will sound. The screen will also show the actual resistance.
Note : if OL appears in the display during a measurement, the value exceeds the range you have
selected. Change to a higher range.
on the screen
on the screen
CAP Hz
CAP Hz
CAP Hz
CAP Hz
15