Operating Instructions
,_
CAUTION: The Remote Controller will not function properly if strong
light strikes the sensor window of the air conditioner or if there are
obstacles between the Remote Controller and the air conditioner,
Power
• To turn the Set ON, push the button. To turn the Set OFF, push the button again.
• This button takes priority over any other buttons.
• When you first turn it on, the Set is on the High cool mode and the temp. at 72°F
Temperature
Setting
• This button controls the room temperature setting in a range between
60°F and 86°F in 1° increments.
Fan Speed
• Pressing the Fan Speed button toggles between Low and
High speeds.
On/Off Timer
- Stopping Operation
Each press of the button cycles through the options in this order:
1 Hour-, 2 Hours-, 3 Hours-, 4 Hours-, 5 Hours-, 6 Hours-, 7 Hours
-, 8 Hours-_ 9 Hours-_ 10 Hours-, 11 Hours-, 12 Hours-, CANCLE.
The set temperature will be raised by 2°F after 30 minutes and
again after another 30 minutes.
- Starting Operation
Each press of the button cycles through the options in this order:
1 Hour -* 2 Hours -, 3 Hours -, 4 Hours -, 5 Hours -, 6 Hours -*
7 Hours -, 8 Hours -, 9 Hours -, 10 Hours -, 11 Hours -* 12 Hours
-, CANCLE.
[
Fan Speed
Energy Saver
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and
check the room air to determine if cooling is needed.
Timer
Mode
Energy
Saver
Cool/Fan/Dry
• Everytime you push this button, it will toggle between COOL, FAN, and DRY.
How to Insert
Batteries
1. Remove the cover from the back of the remote
controller
2. Insert two batteries.
• Be sure of the polarity when installing the
batteries.
• Be sure that both batteries are new.
3. Re-attach the cover.
@
®
• Do not use rechargeable
batteries. Such batteries
differ from standard dry cells
in shape, dimensions, and
performance.
• Remove the batteries from
the remote controller if the air
conditioner is not going to be
used for an extended length
of time.
18
Room Air Conditioner