Idea FCS Serie Manual De Usuario página 6

Installation
STEP 1
Using a stud finder (available at low cost at most hardware stores) or other accurate method, locate center point between two joists
and mark. Using template provided, trace hole pattern on surface of ceiling.
STEP 2
Using a sabre saw, keyhole saw or very sharp utility knife, cut hole in ceiling. Following trace pattern.
STEP 3
Run loudspeaker wire to sound source location.There are serveral methods you can use to accomplish wiring, depending on the
construction characteristics of the room or house.You can add a professional touch to your installation by using a speaker terminal
plate at the source location. Leave sufficient amount of wire at speaker location (8-10 inches / 20-25 cm) to complete connection.
STEP 4
Attach loud speaker wires to speaker terminals, observing correct polarity and position speaker frame up into cutout. Be careful not
pinch wires in the process.
STEP 5
Carefully tighten the four mounting screws. This will cause the mounting wings to rotate our behind the mounting surface and secu-
re the speaker in place.
- 6 - User Manual