Monster SmartView 300S Guía Del Usuario Y Garantía página 12

Installing the Wall Mounting Plate
Remove all pieces of the wall mounting system to ensure
you have all the necessary parts.
Wood Stud Mounting:
1)
Using an electronic stud sensor, locate a wall stud
at your desired mounting location.
�����
2)
With the help of a friend, position the wall
�����
mounting plate on the wall stud. Using the provided
level, confi rm that the wall plate is plumb or vertically
straight. For best results, position the level horizontally
with the narrow end fl ush against the side of the wall
plate. Hold the plate fi rmly in place.
3) Mark the stud center in the top and bottom mounting
holes with a pencil.
4)
With your electrical drill and 3/16" bit, pre-drill a 3"
deep hole at each mark.
5)
Attach the wall plate to the wall using the lag bolts
and round washers as shown below. Tighten each bolt
with your electric drill or socket wrench. Turn clockwise
until secure.
DO NOT over tighten bolts. This can damage
the wall plate or the surface of your wall.
DO NOT release the wall plate until you are
absolutely sure it is secured to the wall.
8