Operation; Charging The Product - EASYHOME MD 18418 Manual De Instrucciones

Operation

Charging the product

• The product contains rechargeable batteries which need
• The product cannot be used during charging and must be
• Always charge the product when there is a noticeable
1. Make sure the handheld vacuum
1
vacuum .
To do so, first insert the suction opening
the lower part of the holder and then push the handheld vacuum towards
the back of the holder until it locks into place (see steps 1 and 2 in Fig. D).
The charging contacts (
can only be in full contact for charging when the handheld vacuum is
inserted correctly.
2. Place the floor vacuum (with the handheld vacuum) onto the charging
station 27 (see step 3 in Fig. D).
Make sure the floor vacuum is upright and the bracket
station is fully inserted into the slot
(see Fig. A and B).
The charging contacts (
station can only be in full contact for charging when the floor vacuum is
inserted correctly.
3. Connect the power adapter
The indicator light in the on/off button
glow red during charging and will turn blue as soon as the product is fully
charged.
4. Once fully charged, remove the power adapter from the wall outlet.
to be fully charged for at least 8 hours before the product is
used for the fi rst time.
switched off during the charging process.
decrease in suction power.
5 and
6 and
24
12 is placed in the holder
18 of the handheld vacuum into
14 ) on the holder and handheld vacuum
7 on the backside of the floor vacuum
29 ) on the floor vacuum and charging
to a wall outlet to start charging.
13
of the handheld vacuum will
Operation
2
of the floor
of the charging
28
17