_1"11Place Air Conditioner in window opening. It
should sit on Bracket assembly so that Curtain
Frame and cabinet Side Guides are against top and
side window jambs. Mate front of Bracket with Base
Guide attached to the bottom of base pan.
_lDrill
1/8 inch holes in window track through the
existing holes on Base Guide. Screw 4 Type C
screws through the holes. (Fig. 8)
_"_lf this is a casement window installation,
proceed to Casement Window Installation. If not,
slide inner window sash firmly against side of the
cabinet.
_-lDrill
1/8 inch hole in window jamb to align with
the existing holes in the Curtain Frame. Attach
Curtain Frame to window frame with 2 Type B
screws. (Fig. 8)
NOTE: Check all seals and plug any remaining air
gaps with a suitable weatherproof caulk.
.J
Type C screw
Window Track
FIG. 8
Type B screv
_!
If this is a casement window installation
proceed to Casement Window Installation. If not,
stuff the Foam Seal Strip between the vertical sash
and the window glass. (Fig. 9)
_J
Attach the L Bracket with a Type B screw. (Fig. 9)
strip
FIG. 9
CASEMENT
WINDOW
INSTALLATION
• Installation procedure is the same as that described in
steps 1 through 11 and step 13 of the Horizontal Sliding
Window installation.
• If the window opening is wider than 15-3/4 inches you
will need to install a filler panel. Make this panel from 3/4
inch thick wood and run it the full length of the window.
Attach it securely to the window frame and paint it to
protect it from the weather.
• Since there is a wide variety of casement window styles
and sizes, these instructions may not be exactly suited
to your particular situation. To ensure best results, have
the work performed by someone skilled in installing
casement window air conditioners.
REMOVAL FROM WINDOW
• Turn off and unplug the air conditioner.
• If horizontal sliding window, remove the L Bracket from
window frame and the Foam Seal Strip from between the
windows.
• Remove the Safety Bracket that you installed in Step 12.
• Unscrew the Curtain Frame from the window frame.
• Remove air conditioner from the window opening.
BE CAREFUL NOT TO DROP IT. Once removed, set it
safely out of the way.
• Remove Curtain Frame and Curtain.
• Unscrew the Side Guides and Upper Guide.
• Place unit and all assembly hardware in air conditioner
shipping carton, and store in a clean, dry place.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-8-