Troubleshooting - LOTRONIC Madison MAD-VR60 Manual De Instrucciones

ENGLISH
Bluetooth Operation
Place the radio and your Bluetooth device not more than 10m apart from each other.
1.
Set the function selector switch (5) to Bluetooth. The selector button must be in FM/AM state.
2.
Activate the Bluetooth function on your device and start searching.
3.
During the search, the radio's LED indicator will flash.
4.
5. MAD-VR60 will appear in the list if found devices.
6. When both devices have been successfully paired, the LED indicator will stay on.
7. Press the Play/pause button to play and pause the music.
8. Press the track buttons to select a track.
9. Adjust the volume and tone controls to the desired level.
Cleaning and Maintenance
•
Please observe all safety recommendations
•
Before cleaning, always pull the mains plug.
•
Clean the housing with a soft, moist cloth and a mild detergent.
•
Never use abrasive detergents or sharp utensils.

Troubleshooting

If a fault occurs, check first the points listed below before taking the unit for repair. If the problem persists,
contact your dealer.
PROBLEM
GENERAL
No Sound
RADIO
Poor reception
Technical specifications
Bluetooth version .......................................................................................................................................................................3.0
Max. RF transmission power .........................................................................................................................................1.016dBm
Bluetooth transmission frequency .......................................................................................................................... 2.40-2.48GHz
FM band ................................................................................................................................................................... 87.5 – 108MHz
AM band................................................................................................................................................................... 530 – 1605kHz
Power supply ................................................................................................................................................... 220-240V~ 50/60Hz
Battery operation .....................................................................................................................9V�� 6x C batteries (not included)
Dimensions ........................................................................................................................................................300 x 80 x 210mm
Weight ......................................................................................................................................................................................1.5kg
The above specifications are for reference only.
Design and specifications are subject to change for improvement without prior notice.
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent pos-
sible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustai-
nable reuse of material resources. To return your used device, please use the return and collection systems or contact the retai-
ler where the product was purchased. They can take this product for environmental safe recycling.
4
POSSIBLE CAUSE
Power cord not connected or no
batteries inserted.
Volume is set too low
Batteries are exhausted
Batteries inserted incorrectly
Weak signal
Interferences by other appliances
(TV sets, VCRs, computers, etc.)
© Copyright LOTRONIC 2019
SOLUTION
Connect the power cord correctly or
insert batteries.
Adjust the volume.
Replace the batteries.
Change to the correct polarity
Adjust antenna:
FM: telescopic antenna
AM: adjust unit
Keep a distance to other electric
appliances