Recommendedgroundingmethod; Electrical Requirements; Installing The Power Cord - Kenmore 580.75063 Manual Del Propietário

OBSERVE
ALL LOCAL CODES AND ORDINANCES.
DO NOT,UNDER ANY CIRCUMSTANCES,REMOVE
THE POWERSUPPLY CORD GROUND PRONG.
ELECTRICAL GROUND IS REQUIREDON THIS
APPLIANCE.
For 230/208volt 60 Hz, AC only, 15A fused and
properlygrounded electricalsupply is required A time
delayfuse or time delay circuit breakeris
recommended Use a dedicated circuit, serving only
this appliance.
DO NOT USE AN EXTENSIONCORD.
115V~
F
230V ~
RECOMMENDEDGROUNDINGMETHOD
Foryourpersonal s afety,thisappliancemustbegrounded.
Thisappliancehasa powersupplycordwitha 3-prong
grounding plug.To minimizepossible shockhazard, t he
cordmustbe pluggedintoa matinggrounding typewall
receptacle and grounded in accordance withthe National
Electrical C ode(ANSI/NFPA 70) latesteditionand all local
codesandordinances, i f a matingwall receptacle is not
available, i t is the personal r esponsibility a nd obligation of
thecustomerto havea properlygrounded 3-prong wall
rece)tacteinstalIed by a qualifiedelectrician.
Powercordmayincludea currentinterrupter
device A test andresetbuttonis provided on the
plug case.Thedeviceshouldbe testedon a
periodicbasisby firstpressingtheTESTbutton
andthenthe RESETbutton If the TESTbutton
doesnottripor if the RESETbuttonwillnot stay
engaged,discontinue useofthe air conditioner and
contacta qualifiedservicetechnician.
NOTE: The shape may be different according to its rnodet
Use Wail Receptacle Power Supply
Standard 125V,
3-wire grounding
receptacle rated
15A. t25V AC
Standard 250V,
3-wire grounding
receptacle rated
r5A, 250V AC
Use I5 AMP. time
delay fuse or 15 AMP
circuit breaker
Standard 250V,
3-wire grounding Use 20 AMP. time
receptacFe rated delay fuse or 20 AMP
20A, 250V AC circuit breaker
Electrical Shock Hazard
Plug into a grounded 3 prong outlet
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
You can choose between the two methods below according to your preference and window sill shape.
USING SLIT "A"
Fasten the stopper using Type A screw, and lead the
power cord out through slit "A".
Screw
-4-
USING SLIT "B"
Fasten the stopper using left screw hole, and rotate
properly to lead the power cord out through slit "B".
Screw (Type ,_
,)