Detailed Setup Guide; Battery Installation; Features; Minimum And Maximum Temperatures - La Crosse Technology WS-9002U Manual De Instrucciones

1. Have the indoor temperature station and remote temperature sen-
sor 3 to 5 feet apart.
2. Batteries should be out of both units for 10 minutes.
3. Place the batteries into the remote temperature sensor first then
into the indoor temperature station.
(All remote temperature sensors must be started before the indoor
temperature station)
4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the indoor temperature station and remote temperature
sensor will start to talk to each other and the display will show both the
indoor temperature and an outdoor temperature. If the indoor tem-
perature station does not display both temperatures after the 15 min-
GB
P.5

DETAILED SETUP GUIDE

I. BATTERY INSTALLATION
A. REMOTE TEMPERATURE SENSOR
GB
P.2
GB
P.7
3. Replace battery cover.
4. Wait 15 minutes before pressing any buttons.
GB
P.9
utes please retry the set up as stated above. After both indoor and
outdoor temperatures are displayed for 15 minutes you can place your
remote temperature sensor outdoors and set your time.
The remote temperature sensor should be placed in a dry, shaded
area. The remote temperature sensor has a range of 80 feet. Any
walls that the signal will have to pass through will reduce distance. An
outdoor wall or window will have up to 20 feet of resistance and an
interior wall will have up to 10 feet of resistance. Your distance plus
resistance should not exceed 80 ft. in a straight line.
NOTE: Fog and mist will not harm your remote temperature sensor
but direct rain must be avoided.
1. Remove the mounting bracket.
2. Remove battery cover
3. Observing the correct polarity, install 2 AA batteries-make sure they
do not spring free, or start-up problems may occur. Replace cover.
B. INDOOR TEMPERATURE STATION
Note: After the batteries are installed, DO NOT press any buttons.
This may interfere with the signals, causing temperatures to register
incorrectly.
1. Remove the battery cover on the backside.
2. Observing the correct polarity, install 2 AAA batteries.
II. FEATURES
A. MINIMUM AND MAXIMUM TEMPERATURES
1. Press and release the "MIN/MAX" button, "MIN" appears in the
temperature LCD's and the recorded minimum temperatures are
displayed.
2. Press and release the "MIN/MAX" button to toggle to the maximum
temperatures.
B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES
1. To reset both the minimum and maximum temperatures-press and
hold the "MIN/MAX" button for 5 seconds.
GB
P.6
GB
P.3
GB
P.8
GB
P.10