D-Link DVG-5121SP Guía De Instalación Rápida página 3

Hardware Overview (continued)
Right Side and Rear Panels
WAN Port
LAN Port
Reset
RJ-11 Phone
Ports (1~2)
RJ-11 Line
Port
<for PSTN>
AC Input
Connecting the DVG-5121SP directly
to a Modem, phone and Computer
If your computer connects directly to a DSL or Cable modem and does not connect to
a router, follow the steps below to install your DVG-5121SP. For any other
configuration, please refer to the user manual located on the CD-ROM included with
the device. After the steps are completed, your setup should look similar to the
diagram below.
Right Side Panel
Connects to your DSL or Cable modem using an
Ethernet cable.
Connects to an Ethernet enabled computer or IP
sharing device using an Ethernet cable.
Rear Panel
This button is used to reset the unit to its factory
default settings.
Connect one or two analog phones using RJ-11
cable (one cable is included with the DVG-5121SP).
Connects the DVG-5121SP to a phone wall-jack
using an ordinary RJ-11 phone cable.
The power adapter connects here.
3