Remote Control - Idylis 0416711 Manual Del Usuario

HEAT MODE:
Note: During Heat Mode, the exhaust hose does not have to be vented outdoors.
1) Press the POWER SWITCH button to switch on the unit, and the most recent set
temperature will be shown in the temperature display area of the control panel.
2) Press the MODE button until the heat indicator light illuminates on the control panel.
Each depression of the MODE key will advance to a different mode setting (Cool-
Dehumidify-Fan-Heat)
3) Press the appropriate increase "+" or decrease "-" buttons to select a suitable
operating temperature setting. Temperature settings are adjustable between 16°C
(61°F) to 27°C (80°F.)
4) Press the FAN button to select the desired fan speed setting (Low-Medium-High.)
Your selection will appear on the control panel (each depression of the fan button will
advance to the next setting.)
Note: Heating stops automatically when the set temperature is achieved. Heating resumes when the
room temperature rises above the "set" temperature level.
AUTO-TIMER:
While the Air Conditioner is in Standby Mode (Auto-On):
1) Press the Timer button once and the adjacent Auto-Timer display will illuminate.
2) Use the Up/Down arrows to select a delayed On Time of up to 24 hours.
3) Select the appropriate mode under which you want the unit to operate (Cool-Dehu-
midify-Fan-Heat)
4) Select the fan speed setting.
5) The time you selected will appear in the LED display.
While the Air Conditioner is on (Auto-Off):
1) Press the Timer button and the adjacent Auto-Timer display will illuminate.
2) Use the Up/Down arrows to select a delayed Off Time of up to 24 hours.
3) Follow the steps 3, 4, and 5 the same as above.
Lowes.com
12
OPERATING INSTRUCTIONS

REMOTE CONTROL:

Control Buttons:
1) Power
2) Mode
3) Fan Speed
4) On/Off Timer
5) Time/Temperature Set
The timer setting is programmable from 1 - 24 hours by first pressing the On/Off Timer button and then
the Time/Temperature Set buttons.
When either the "+" or "-" button is pressed in cool mode, the set temperature is displayed and may be
adjusted. After 15 seconds, the display will revert back to room temperature.
Two AAA Alkaline batteries (R) (included) are required to operate the hand-held remote control.
Batteries should be replaced when:
a) No signal (beep) is heard when attempting to program the main unit using the remote.
b) The main unit does not respond to a command issued by the remote control.
Battery replacement:
1) Gently slide the rear cover on the remote in the direction of the arrow until it separates completely
from the unit.
2) Insert two Alkaline AAA batteries (R) following the same orientation (polarity) depicted inside the
battery chamber (+/-).
3) Reinstall the rear cover.
4) If the remote control will not be used for extended periods of time, the batteries should be removed.
1
5
3
4
2
Lowes.com
13