Odys DPF Retro II Manual Del Usuario página 8

Setting alarm
While in the Alarm mode, press and hold the Enter key for 2 seconds, the hour and will start to flash. Use the UP/DOWN arrows
to set the desired hour and minutes. Press the Enter key to confirm
Press any key to stop the alarm.
Delete Pictures
When in the Digital Photo Album mode, press the Menu key
Press the Up/Down key to select Delete One or Delete all.
Press the Enter key to confirm.
Caution!
By pressing the Enter key the last viewed photo will be erased directly without further notations.
The unit will enter the photo mode.
USB Mode
Install the software provided and follow the instructions shown on the screen.
Once the installation has finished, connect your Device to a free USB Port and select the USB update mode as shown above,
start the PhotoViewer Software.
Use only the software provided to copy images to the device.
Direct access to the removable disk ist not possible.
Once installed, connect the Device in USB update Mode and start the software to modify your images.
When the USB cable is connected, the unit will enter the USB mode and the screen shown to the right will be
displayed.
Press the Up/Down key to select USB Power or USB Update.
Press the Enter to confirm.
• If USB Power is selected, the unit will use the USB power as the main power source.
The unit will enter the photo mode and a USB icon and Battery icon will be shown in the lower left corner of the display.
To change the USB mode please disconnect the device from your computer and connect it again.
• If USB update is selected, the following will be shown on the display.
Open the PC software to add / delete images to / from the internal memory.
Unplug the USB cable to resume normal function.
U d t