Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Perimeter
of cut out
Drill a clearance hole just inside
the perimeter line.
Perimeter
of cut out
Cut opening along the perimeter
of the cut out line.
5
After checking fit and alignment, turn sink upside down
and apply clear silicone adhesive around the under
side of the rim near the edge. Place sink in position.
Wipe off excess adhesive.
7
B
Connect trap to drain assembly hand tight to check alignment. It
may be necessary to cut off part of the tailpiece (area "B") or part
of the horizontal leg of the trap (area "C"). Secure joints for
watertight assembly.
C
4
Mount the faucet and drain assembly (not included) on the sink
following the manufacturer's instructions. Be certain to apply a bead
of sealing putty on the underside of the drain (Part "A") in order to
ensure a watertight seal between the sink and drain. Remove
excess putty after installing drain on sink.
6
Shut-Off Valves
Connect supply line to faucet (finger tight) and carefully bend
tubes to engage with the supply shut-off valves. Tighten
connections at faucet and shut-off valves for secure seal.
8
- 3 -
A
7 3 01 2 81 - 10 0
Publicidad
Tabla de contenido
