Prepare The Downdraft - KENMORE ELITE 233 5996 Serie Manual De Uso Y Cuidado

CHANGING BLOWER DISCHARGE (Optional)
The blower is shipped with its discharge facing DOWN. Follow these
steps ONLY if:
• the position of the blower discharge needs to be moved so
ductwork does not interfere with floor joists, plumbing or
wiring below.
• it is necessary to rotate the blower discharge to the RIGHT
or LEFT.
Place the unit on its back on a table or work surface.
DOWN DISCHARGE - MOVING BLOWER LEFT OR RIGHT
1. Loosen the 4 nuts and 2 clamp channels.
2. Slide blower to desired position.
3. Use supplied cover plate to close open space (if any).
4. Tighten nuts to secure top of blower and use sheet metal screws
through bottom flange to secure bottom of blower.
LEFT OR RIGHT DISCHARGE
1. Remove the 4 nuts and 2 clamp channels.
2. Carefully lift blower and disconnect motor plug if necessary.
Reposition blower and RECONNECT MOTOR PLUG.
3. Use supplied cover plate to close open space (if any).
4. Replace clamp channels and use nuts to secure the blower in its
new position.
5. Use sheet metal screws through bottom flange to secure bottom
of blower.

PREPARE THE DOWNDRAFT

7