babyjogger 2014204 Instrucciones Del Ensamblaje página 3

2 Connect the two L-shaped bars to complete the support bar.
3 Insert the support bar into the Adapter Brackets until it clicks
into place.
4 Snap button position 1 is used for the Britax B-Safe 35 and
B-Safe 35 Elite. Snap button position 2 is used for older Britax
B-Safe car seats.
5 Place car seat on the car seat adapter brackets and press
down firmly until it clicks into place.
To remove car seat:
Follow the steps in your car seat' s instruction manual to
remove car seat from adapters.
To remove adapters:
6 Press gray release button on each adapter and pull upward
to remove.
WARNING:
• Keep these instructions for future reference.
• Read these instructions carefully before use. Your child' s safety
may be affected if you don't follow these instructions.
• NEVER leave child unattended.
• IMPORTANT! While the child is in the carseat, always use the
restraint system provided by the manufacturer.
• WARNING: Check that the car seat attachment devices are
correctly engaged before use.
• Accessories not approved by Baby Jogger® shall not be used.
• Only use replacement parts supplied or recommended by
Baby Jogger®.
• Wipe clean using a damp cloth.
3