Publicidad
Idiomas disponibles
Idiomas disponibles
HITAKA SENSOR
117
100
27
HITAKA 10W
IP65
220-
240V ac
AVISO
ANTES DE COMENZAR LA INSTALACIÓN DE ÉSTE PRODUCTO,
POR FAVOR, LEA ATENTAMENTE LAS INSTRUCCIONES Y
GUÁRDELAS EN UN SITIO SEGURO.
LA
INSTALACIÓN
DEBE
CUALIFICADO.
LA GARANTÍA CUBRE ÚNICA Y EXCLUS4AMENTE EL PRO-
DUCTO SUMINISTRADO.
LAS AVERÍAS OCASIONADAS POR INSTALACIONES FUERA
DE LO QUE INDICA EL REBT 2002 EXIMEN DE LA VIGENCIA
DE LA GARANTÍA EN LOS PRODUCTOS DAÑADOS.
ES DE OBLIGADO CUMPLIMIENTO EN INSTALACIONES IN-
TERIORES LA APLICACIÓN DEL ARTÍCULO 16, PUNTO 3 DEL
REBT 2002.
RESPETAR
LAS
MANIPULACIÓN DE LOS COMPONENTES
SENSIBLES
ELECTROSTÁTICAS (LED).
134
117
HITAKA 20W
100º
25.000h
REALIZARLA
PERSONAL
PRECAUCIONES
DE
A
DESCARGAS
BROWN
YELLOW/GREEN
BLUE
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
164
146
28
HITAKA 30W
PRECAUTIONS:
• This product is for outdoor use.
• Do not handle the product while it is in operation. When handling, switch
off the power supply.
• Do not immerse this product in water or handle it with wet hands.
• If the product is damaged, replace it with a new one.
• In the event of breakage or damage to the protective glass, it must be
replaced immediately.
• Do not touch the body of the protector when it is hot.
• Carefully follow the instructions in this manual.
• If in doubt, consult a qualified technician.
• The flexible cable or outer cord of this luminaire cannot be replaced; if
damaged, the luminaire must be destroyed.
• The connection block is not included. The installation may require the
intervention of a qualified person.
• The luminaire should be positioned so that a long look at the luminaire at a
distance closer to x 1m is not expected.
ASSEMBLY INSTRUCTIONS:
1. Turn off the power.
2. Remove the bracket from the luminaire.
3. Attach the bracket to the mounting surface with the appropriate screws.
4. Attach the luminaire to the bracket with its accessories.
5. Connect the line (L), neutral (N) and ground cables (
the power cord.
6. Adjust the position of the luminaire and tighten the screws.
7. Turn on the power.
The luminaire can be connected to the mains via
a connection block, e.g. Stucchi type 1602/VCB-
SM, 2602/VCB-SM. As an alternative, a watertight
connection block can be used, e.g. Techno type
THB384A1A, THB384B1A.
220
200
36
HITAKA 50W
39
) correctly to
Publicidad
