Publicidad
Idiomas disponibles
Idiomas disponibles
Install Only on CDV15-B & C / CDV25-B & C / CDV33-B & C Series
Step 1: Remove outer casing.
Step 2: Remove floor shield from bottom of heater and disconnect piezo wire.
Step 3: Remove and discard cover shield. Save screws.
Step 4: Attach blower to bottom of floor shield using screws saved in step 3.
Note: blower motor should be on opposite end from piezo.
Step 5: For models cdv25/33-b&c, secure p/n 43635 wire guard to bottom of heat shield using two (2)
#8x1/2" screws provided. See Figure 1.
Step 6: Connect piezo wire and attach floor shield to heater. Slide the white cable clamp (provided) over
both motor lead wires and the power cord. Secure to left side of heater with the front screw used
to secure the floor shield.
Step 7: Attach the junction box to left side of wrapper using four #8x1/2" screws provided.
Step 8: Plug power cord into a 115 volt grounded outlet.
Step 9: Replace outer casing and follow lighting instructions to place heater in operation.
THE UNIT MUST BE ELECTRICALLY GROUNDED ACCORDING TO THE NATIONAL ELECTRICAL CODE ANSI/NFPA
NO. 70-1987. THIS APPLIANCE IS EQUIPPED WITH A THREE PRONG GROUNDING PLUG. FOR YOUR PROTECTION
AGAINST SHOCK HAZARD, THIS APPLIANCE SHOULD BE PLUGGED DIRECTLY INTO A PROPERLY GROUNDED
THREE-PRONG RECEPTACLE. DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THIS PLUG.
NOTE: This blower assembly is equipped with a temperature activated fan switch that will automatically cycle the blower
on when the heat exchanger has reached a predetermined temperature. Once the burner shuts off, this switch will cycle
the blower off after the heat exchanger cools to the fan switch differential setting. This blower will not operate unless
the main burner is in use.
CDV15-B & C
70925-A
MODEL DVB-3 OPTIONAL BLOWER KIT
INSTALLATION INSTRUCTIONS
FIGURE 1
CDV25-B & C / CDV33-B & C
Page 2
English Manual
Publicidad
