Water Supply Connections; Hose Connection - Pfister CONTEMPRA 49 Serie Manual De Instrucciones

10
10G
10F
10D
10E
10A
10B
10A
10A

10 HOSE CONNECTION

From underneath sink, push Center Connector (10A) onto receiving Tube (10B), until
unable to push any further. Pull down on Center Connector (10A). If the housing and
the Inner Collet (10C) separate slightly but do not pull off receiving Tube (10B), the
connection is secure.
To remove, push up on Center Connector (10A) holding plastic Collet (10C) in place,
pull down on Center Connector (10A) until Tube (10B) is free.
Slide the End Connectors (10D) with arrow (10E) pointing up onto the Valve Bodies
(10F). Push the End Connectors (10D) all the way up until completely seated. Be
careful not to damage O-Rings (10G).
10B
10G
10F
10D
10B
10C
10C
10A
ENGLISH
11
11C
11D
11A
11D
11E

11 WATER SUPPLY CONNECTIONS

First, thread Inlet Connectors (11A) into Water Supply Lines (11B). Then, insert Inlet
Connectors (11A) into Valve Bodies (11C). Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer's instructions when installing supply lines. Next, insert Clips (11D) into
Valve Body Holes (11E), to secure unit.
WARNING: Do not twist Inlet Connectors (11A) once installed!
DRAIN BODY INSTALLATION
12
12A
12 POP-UP INSTALLATION
Install and adjust Pop-Up (12A) using separate instructions supplied with the Pop-Up
assembly.
4
11D
11B
HOT
11B
COLD
11C
11A