Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STROBE CONTROLLER
TECHNICAL CHARACTERISTICS.
•
Assembly:
All STROBE modules are aligned in rows by simply snap locking them onto the
o
symmetrical mounting rail in accordance with EN 50 022 (DIN 46277/3). They are
removed by pulling back the orange snap lock.
Type of housing:
o
Dimensions:
o
•
Power: +24Vdc. 3A.
The system disposes of large capacity condensers, which are able to store enough power to give
the output pulses.
•
Outputs:
Quantity: 3
o
Type: open drain MOSFET, +24Vdc common.
o
Maximum intensity by output: 6 Amp.
o
•
Inputs:
Quantity: 3 + common ground.
o
o
Trigger: negative or positive edge trigger equal or great than +5Vdc.
o
Minimun voltage: 0Vdc.
o
Maximun voltage: +24Vdc.
o
Input impedance: 60KOhms.
o
•
Led indicator:
Power: A green led comes on when the power is switched on.
o
Running: A blinking red led indicates when the system is operative.
o
RS-232: A red led is activated when there is communication.
o
DCM Sistemes S.L.
http://www.dcmsistemes.com
STROBE CONTROLLER
Controller of three outputs of 6A each one, with
independent
programmable pulse between 0 µs and 10 ms in
steps of 4µs. Programming via RS-232 stored in
non-volatile memory.
Polycarbonate PC-F fiber reinforced
Inflammability class V0 (UL94) color: black
Width: 90mm.
Deep: 103mm.
Height: 75mm.
inputs
of
pulse
e-mail: comercial@dcmsistemes.com
User manual
wide
and
Page 5
Publicidad
Tabla de contenido
