GRABBER ROCKER 4025 Manual De Instrucciones página 6

GRB/386312-02 8/11/00 1:56 PM
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
The label on your tool may include the following symbols.
V ....................................volts
A ....................................amperes
Hz ..................................hertz
W ....................................watts
min ..................................minutes
..................................alternating current
................................direct current
n o....................................no load speed
.................................... Class II Construction
.../min ..............................revolutions or reciprocation per minute
....................................earthing terminal
....................................safety alert symbol
Switch
To start tool, depress the trigger switch, shown in Figure 1. To stop
tool, release the switch. The variable speed trigger switch permits
speed control. The farther the trigger switch is depressed, the higher
the speed of the tool.
Page 2
2
FIG. 1
REVERSING
LEVER
TRIGGER
SWITCH
LOCKING
BUTTON
BIT TIP
DEPTH
HOLDER
LOCATOR
FIG. 3
ADJUSTMENT
BIT
COLLAR
CLUTCH
TIP
HOUSING
FIG. 4
NUTSETTER
BIT
FIG. 2
BALL GROOVE
1/4" HEX
DRIVE
BALL
RETAINER
RETAINING
SPRINGS
LOCATOR
ADJUSTING
COLLAR
NUTSETTER
CLUTCH
HOUSING