Wagan Tech Wet & Dry Ultra Vac Manual De Usuario página 2

Wet & Dry Ultra Vac by Wagan Tech
Thank you for purchasing the Wet & Dry Ultra Vac by Wagan Tech. With normal care
and proper treatment it will provide years of reliable service. It is important to read and
understand all operating instructions and warnings before use.
WARNINGS!
• This vacuum cleaner OPERATES FROM 12 VOLT SOCKETS ONLY and is designed
for use with the 12-VOLT cigarette lighter socket in your car.
• You MUST ENSURE that all other electrical equipment in the car are SWITCHED
OFF when vacuum is in use.
Parts & Accessories:
1. Detach the dirt reservoir by releasing the three clips located around the reservoir.
2. Remove all contents from the reservoir and make sure you have the following:
• 9-feet long 12V DC cord: plugs directly into the cigarette socket
• 40-inch flexible hose that bends to access all hard to reach areas
• Wide Nozzle: for use on liquids
• Bristle: attachable to wide nozzle, ideal for upholstery
• Crevice Nozzle: allows you to clean under seats and other narrow areas
• Inflating adaptor: for pumping air into sports equipment, air mattresses, etc
3. Resecure the reservoir back in place with the three clips.
Vacuuming Instructions:
1. Select the attachment you wish to use and connect it to one end of the hose.
2. Connect the other end of the hose to the Vacuum Port.
3. Plug the DC cord into your cigarette socket.
4. Locate the power switch on the motor housing underneath the casing handle and
turn the unit on. (Tip: It is a good idea to leave your car running while operating
this unit to avoid draining your battery.)
5. When finished, turn the unit off using the same power switch then unplug the DC
cord from the Cigarette socket.
6. Clean out dirt, debris, and etc from the reservoir by unlatching the three clips in the
same manner as described in "Parts & Accessories".
7. Return vacuum parts back into the canister for storing.
www.wagan.com
1
User's Manual—Read before using this equipment
Inflating Instructions:
1. Connect the Inflator Adapter to one end of the hose.
2. Connect the other end of the hose to the Inflator Port.
3. Follow steps #3-7 from the Vacuuming Instructions.
Maintenance & Care:
• DO NOT submerge vacuum in water.
• After using the Wet & Dry Ultra Vac to vacuum up liquid, make sure to clean the
reservoir and filter. Let all parts dry FULLY before storing it away for future use.
Technical Specifications:
• Operating Voltage: 12 Volts
• Operating Wattage: 100 Watts
Hose
Inflator Port
Casing Handle
Power Switch
Motor Housing
Vacuum Port
Liquid/solid Reservoir (1 gallon)
Securing Clips (x3)
12V DC cord
Inflator Adapter
Crevice Nozzle
Wide Nozzle
Bristle (detachable)
© 2010 Wagan Corporation
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
All Rights Reserved
2