Directions For Use; After Each Use; Troubleshooting Guide - Guardian Technologies SPA125 Instrucciones De Uso Y Cuidado

PRODUCT SPECIFICATIONS AND PARTS
MODEL NUMBER: SPA125
DIMENSIONS: 2.875" L x 2.25" W x 1.875" H
POWER SUPPLY: USB plug
WEIGHT: 1.8 ounces
Top cover
Absorbing pad
USB port
• Includes 5 absorbent pads
E-4
1. Remove the cap of the diffuser
by twisting counter clockwise.
4. Secure cap by twisting
clockwise.

AFTER EACH USE

USB Plug
1. Turn the device off and unplug the diffuser from the USB power outlet or computer.
2. Twist off the top cover and remove the individual scent pad.
3. Wipe the diffuser with a dry cloth. Do not use a Q-tip to clean.
IMPORTANT: Do NOT fill with water as this may cause damage to the diffuser. Remove diffuser from
USB Power Outlet or computer when not in use.
Push
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF,
On/Off Switch
DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE DIFFUSER OR PERSONAL INJURY.
PROBLEM
No aroma is produced.
The diffuser mist has a bad smell.
Increased noise level.
The USB ports are not charging
another device.
The aroma is too light.
Aromatherapy essential oils can be purchased at www.guardiantechnologies.com

DIRECTIONS FOR USE

2. Pour 3-5 drops of essential
oil on one absorbing pad.
5. Plug the diffuser into a USB
power outlet or computer
and push the ON/OFF button.

TROUBLESHOOTING GUIDE

SOLUTION
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Clean the product thoroughly, and replace pad.
Unit must be placed on a flat, level, hard surface.
Make sure it is NOT placed on soft or absorbent surface.
Unplug and then try again. Check that diffuser power is on.
Add more drops of oil mid-cycle.
3. Place pad into diffuser.
6. Charge your cell phone
only on the USB ports
behind the diffuser.
E-5