Setup - digi-tech 4-LD3030 Manual Del Usuario

Setup

Open the battery compartment on the back side of
the station and insert 2 x AA batteries in the correct
polarity. Close the battery compartment. Please
remove the protective film from the display.
The radio tower symbol will appear on the display
without radio waves. After a few seconds the radio
time signal reception will begin. The radio waves
now appear blinking on the display. The time and
date will appear automatically after the time signal
is received.
Position the station and the sensor next to each
other. Open the battery compartment on the back
side of the outdoor sensor and insert 2x AA
batteries in the correct polarity. Close the battery
compartment.
The outdoor sensor signal will now be received by
the main unit and the outdoor temperature will
appear after a few minutes.
Note
If the radio controlled time does not appear after 5
minutes, please move the temperature station to a
different location at your site or set the time
manually.
The reception process can be restarted at any time
by pressing and holding Zz/REGISTER.

- 27 -