4. Maintenance
1) Changing and cleaning the anti-grease filters.
In order to prevent fire hazard, it is recommendable to clean the filter at a
maximum of 2 months by carrying out the following instructions.
Before cleaning, make sure that the appliance is plugged off.
Removing the filters.
Clean the filter as below measure:
i. Soak them for about 3 minutes in hot water (40-50 degrees) with a
grease-loosening detergent then brush it gently with a soft brush. Please
do not apply too much pressure to avoid damaging it.
ii. It can be put into a dishwasher with detergent, set the temperature at
around 60 degrees.
Do not use abrasive detergent otherwise it will damage the hood.
2) Changing the light
Before changing the lights, make sure that the appliance is plugged off.
Press out the glass of lamp and turn it contradictorily until the lamp loosen
Take out the fault lamp and fix the new lamp (Max. 40W GU10 lamp) as the
opposite way.
GB-7