Function And Response Table; Set The Boundary Width And Test The Receiver Collar - Petsafe PRF-3004XW-20 Manual De Funcionamiento

Function and Response Table

Indicator Light Response
1 Flash
2 Flashes
3 Flashes
4 Flashes
5 Flashes
Flashes once every 5 seconds
Set the Boundary Width
Step
6
and Test the Receiver Collar
The Boundary Control Switch on the side of the
Fence Transmitter has three settings (6A). Setting B
is used for most properties. The following table will
indicate the setting you should use.
Amount of Wire
Up to 396 m (1300 ft)
396 m - 732 m (1300 ft - 2400 ft)
Greater than 732 m (2400 ft)
Use the Boundary Width Control knob to set the
width of the Warning Zone and Static Correction
Zone (6B). Set the Boundary Width as wide as
possible to give your pet the widest Warning and
Static Correction Zones without reducing the
Pet Area too much. We recommend a 3.7 m - 6 m
(12 ft - 20 ft) Boundary Width.
Note: The Boundary Width Control knob does not
change the Static Correction Level.
To prevent an unintended
correction:
- The receiver collar should not be on your
dog when the system is tested.
- Remove the receiver collar before
making any changes to your system.
- Before placing the receiver collar on your
pet, test the boundary location and width
after any change.
To identify the Warning and Static Correction
Zones, make sure the Receiver Collar battery is
properly installed and the Test Light Contacts
are touching the Contact Points (6C, 6D). For
best results, select a section of straight Boundary
Wire that is at least 15 m (50 ft) long. Hold the
Test Light contacts to the Contact Points. (6D).
12
Static Correction Level
1
2
3
4
5
6A
Setting
B
C
A
6C
Test Light Contacts
6E
petsafe.com
Collar Receiver Function
Tone and Vibrate (No Static Correction)
Low Static Correction
Medium Static Correction
Medium High Static Correction
High Static Correction
Low Battery
6B
5
2
5
2
6D
6F
8
8
Boundary
Wire