Safety Directions; Technical Specifications; Power Supply - Airwell AQUASIMP Manual De Regulación

SAFETY DIRECTIONS

Any wiring produced on site must comply with the corresponding national electrical regulations.
Make sure that the power supply and its frequency are adapted to the required electric current of operation, taking
into account specific conditions of the location and the current required for any other appliance connected to the
same circuit.
Cutoff power supply before starting to work on the appliance.
In order to become fully familiar with the appliance, we suggest to read also our Installation and maintenance
manual with the the Technical Department of your area.
The informations contained in these Instructions are subject to modification without advance notice.
All interconnecting wires and probes must be double insulated (230 V mains supply) and comply with
local electrical standards.
USE
LED
²
On= Heating or Cooling ON
² Off = No demand
² Slow flashing = Difference between
water temperature and mode
² Rapid flashing = Probe fault
Fan speed:
²
HS
² MS
² LS

TECHNICAL SPECIFICATIONS

Power supply

² Voltage: 230V AC ±10% /50Hz.
² Power consumption – Circuit board only = 1W (OFF mode = 0 W)
Wires
² 1 mm²
² Maximum distance: 30m
MODE:
² Heating
² Off
² Cooling
1
Set temperature point:
² 10°C to 30°C

Hotter

Cooler