Flex-a-Lite Black Magic 175 Instrucciones De Instalación

for the FORD MUSTANG 5.0 (1986-1993)
Prior to fan installation
1. Remove fan, fan clutch, shroud, and radiator overflow tank. Replace the bolts to the water pump
pulley. Rotate the water pump pulley to verify clearance of bolts to waterpump housing.
Note: Save the screws and clip-on nuts from the top of the radiator channel and from the shroud.
Overflow tank and bracket installation
2. Remove the clip-on nut from the top of the passenger side radiator channel. Place the clip-on nut
on the bottom of the drivers side radiator channel. Use the original screws to mount the overflow
tank bracket to the radiator. (see Diagram A)
3. Remove the 2 clip-on nuts from the original fan shroud, attach them to the holes on the overflow
tank bracket provided in the kit. Use the original screws holding the overflow tank to the original
shroud to attach the overflow tank to the new bracket. (see Diagram A)
175 Electric fan mounting instructions
4. Loosely fasten angle brackets to the ends of the square tubing on the temperature sensor side of the
shroud. (see Diagram A) Hook the fan unit to the top of the radiator channel. (see Diagram B)
5. Position the fan unit between the overflow tank and the passenger side radiator tank.
Square Tube
(Threaded Strut)
Overflow
T ank
Bracket
Clip-on Nut
(From the top of the
passenger side of
the radiator.)
Diagram A
Installation Instructions
Bolt
Lock
Washer
T op Angle
Bracket
Spacer
Lock
Angle
Washer
Bracket
Bolt
175
6. Push the bottom of the fan unit towards the
lower radiator channel, while holding the
fan unit to the radiator hook one end of the
angle bracket to the radiator and pass the
lock washer and bolt through the angle
bracket and spacer, fastening it to the
square tubing. Push the fan unit towards
the radiator and tighten the bolts until
snug. (see Diagram B)
7. Tighten upper bracket bolts, check to see
that the fan unit is secure.
8. See wiring instructions on back page.
Upper Channel
Lower
Channel
Page 1 of 4
Diagram B