Charging Instructions - HAMPTON BAY 414-713 Manual De Instrucciones

CHARGING INSTRUCTIONS:

All solar-powered lighting requires a sufficient amount of sunlight to recharge the battery(s).
Solar lighting performance is based on the amount of sunlight received during the day. Your
Solar Light can run up to 10 hours when fully charged. Place your solar light in an area which
is free from cover, shade or shadow. Note that if it is placed in a shaded area, the performance
may be dramatically reduced. In winter months or on cloudy days, the time required to fully
charge the battery(s) will increase.
BATTERY CARE INSTRUCTIONS:
Use one 26650 Lithium Phosphate (LiFePO4), 3000mAh, 3.2V rechargeable battery. For best
performance, replace with rechargeable 3.2V LiFePO4 battery every 3 years or when
performance diminishes. Refer to the following steps and the illustration provided to replace
battery.
1. Loosen 2 lock screws (B), remove top cap assembly (A) from housing (C).
2. Remove battery cover plate (F) from top cap assembly (A) by loosening 4 screws (G) as
shown on diagram below. NOTE: To reduce the risk of damage to electrical connections,
exercise caution when separating the battery cover plate (F) from the top cap assembly (A).
3. Disconnect the wire connection of battery lead (I) and remove the old battery from battery
compartment located on battery cover plate (F) as shown on diagram below. Replace with a
new 26650 LiFePO4, 3000mAH, 3.2V rechargeable battery pack.
4. Reassemble battery cover plate (F) and top cap (A), with screws (B & G).
IMPORTANT: Use Rechargeable Battery only. Battery(s) must be recycled or disposed
of properly. Replacement battery Model 46240-000RB is available at
or by emailing CustomerService@Creative-prc.us.
3
www.creative-prc.us