Fellowes MS-460Cs Manual Del Usario página 3

Ocultar thumbs Ver también para MS-460Cs:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.
Continuous operation:
10-12-minute maximum
Set to ( )
and plug in
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond
10-12-minutes will trigger a cool
down period to resume operation.
TROUBLESHOOTING
Paper jam: Set to Off ( ) and empty bin. Replace bin and follow any or all of the below procedures.
Press and hold
Alternate slowly back and forth
Reverse ( )
ATTENTION: If the SafeSense
®
light remains on, you must engage the
(See SafeSense
®
instructions below.)
paper jam: If the SafeSense
SafeSense
®
feature and clear the paper. Warning – when switch is in override position, the SafeSense
the SafeSense
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
MAINTENANCE
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
Shredder stops running
WARRANTY
material and workmanship and provides service and support for 2 years from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material
and workmanship for 7 years from the date of purchase by the original consumer. If any part is found to be
option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure
to comply with product usage standards, shredder operation using an improper power supply (other than listed
on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional
PAPER
Press Auto-On ( )
CARD/CD/3.5 DISK
Press Auto-On ( )
Set to Off ( )
and unplug
Override Switch
feature activates (SafeSense
®
®
Override Switch to deactivate the SafeSense
Follow oiling procedure below and repeat twice.
*Apply oil
Press Forward
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Feed into paper entry
and release
Hold card/CD/
3.5 disk at edge
Gently pull uncut
Press and hold
paper from paper
Reverse ( )
entry. Plug in.
light remains on) to cause the user
®
®
light will flash and
feature.
®
Shred one sheet
costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold
product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are
more details or to obtain service under this warranty, please contact us or your dealer.
Set to Off ( )
and unplug
Feed into card/CD/3.5
disk entry and release
Indicator lights:
®
active
®
not active
Make sure bin is pushed in
Wait for motor to cool down
®
feature.
Sensor light illuminated–paper
10
SafeSense
override switch
®
Active
Not active
Press and hold Reverse ( )
2-3 seconds
3

Publicidad

Tabla de contenido
loading

Tabla de contenido