Midwest Pet Gate 2929SW Manual Del Usuario página 6

To Open the Gate
1. Pull the release button back with your thumb.
2. Lift up on the door panel.
3. Swing open in either direction.
To Close the Gate
1. Release the door within ten inches of the frame and it
will close and latch automatically. If it does not latch
automatically, the gate might not be positioned evenly
within the opening and perpendicular to the floor. If
needed, adjust accordingly. CAUTION: After closing the
gate, ALWAYS check to be certain that it is latched
correctly.
Instructions for Adding 3" Gate Extension
1. Begin by determining which extension or combination
of extensions is required for your doorway opening.
Attach the Top Plastic Connector and Bottom Plastic
Connector to the top and bottom of the Extension Rod.
NOTE: The insertion point of the Top Connector is ¾"
wide, and the insertion point of the Bottom Connector is
5/8" wide.
2. Using a flat head screwdriver, remove the Top Plastic
Insert and the Bottom Plastic Insert from the gate
frame as shown.
3. Connect the Extension Rod to the gate frame as shown.
4. Install the Top Plastic Insert and Bottom Plastic Insert
that were removed in Step 2 into the ends of the
extension bar's Top and Bottom Plastic Connector.
5. Once the required extensions are attached to the gate,
insert the 4 Threaded Spindle Bolts into the ends of the
extensions you just assembled and follow the
instructions from the pet gate starting from Step 1.
Insertion Part
3/4" wide
Insertion Part
5/8" wide
6