Wile Bio moisture Instrucciones De Operación página 17

If you do not want to include the measurement result into the average
calculation, don't make anything after the measurement, just wait until
the meter automatically goes off and is ready for the next
measurement.
Before calculating the average value of every new lot of material,
make sure that average calculation memory is empty and erase
it if needed.
3.4.2
Push and hold the MENU- button. Switch on the meter with a single
press on the ON/OFF- button.
When you see A on the display, release the MENU- button. If the
average value appears on the display now, you can erase it by
pushing and holding the MENU- button. The memory is erased, when
0 appears on the display.
Note! Always remember to erase the average calculation
memory after the measurement series so that the previous
average value will not affect the average value of the new lot.
Average calculation memory can accomodate maximum 99 results. If
no more results can be added to the memory, the number on the
display will start blinking.
3.4.3
If the quality of the measured material is different from normal, the
result can be incorrect. You can adjust the result shown by the meter
to conform with a reference value.
- Adjusting the value upwards
When the measurement result is displayed make the double press on
the MENU- button. Three bars will appear on the upper edge of
the display. Wait for a moment and the result appears on the
display again. Now each time you push the MENU- button, 0,1
moisture % will be added to the result.
- Adjusting the value downwards
When the measurement result is displayed, push the MENU- button
for three times. Three bars will appear on the lower edge of the
display. Wait for a moment and the result appears on the display
Erasing the average calculation memory
Adjusting the result
EN
17