Bevel Cuts - Truper CEPEL-3-1/4A4 Manual De Instrucciones

Start Up
Shaving extraction
• The brush has a shavings ejector duct that can be positioned to
eject from the right or left (A)
• The duct runs through the brush from side to side through the
ejector ducts, blocking one of the ducts and allowing shavings to
exit through the other. To release the duct, move the locking
latch (B) in the direction indicated by the arrow and push it out.
To place it, insert it from the right or left and push it until it is
locked by the lock.
• You can attach the dust collection bag to the open chip ejector
for easy disposal.
• You can connect a workshop dust extraction system or a
household vacuum cleaner to the chip ejector, making the
working environment safer and cleaner.
Planing
• Set the adjustable base onto the work piece surface. The
blades should not make contact with the piece (figure 1).
• Start the tool and wait for the blades to reach the maximum
speed.
• Holding the tool with both hands, advance it gently by
applying pressure to the front of the auxiliary handle (2). Planing
will be easier if the workpiece is slightly inclined so that the
planing is downwards.
• Push the tool beyond the work piece but not leaning
downwards (3).
• The planing speed and cutting depth determine the finish
quality. To get a rough cut increase the cutting depth. To get a
fine finish diminish the cutting depth and push the tool slower.
CAUTION
An extremely fast pass of the tool may produce
bad quality cuts and will damage the blades or the motor. If the
movement is to slow, you may burn or damage the cut.
The right advancing speed will be dependent of the type of
material being cut and the planning depth. Before planning the
work piece, make some tests using a piece of scrap wood to
gauge the right speed and the dimensions of the cut.
WARNING
Secure the work piece using clamps to prevent
accidents and defects in the cut.

Bevel Cuts

• For bevel cuts or chamfers, match the work piece edge with
one of the two notches in the adjustable base.
• Make passes with the planer aligning the notch on the corner
edge.
A
1
2
3
B
9
ENGLISH