Door Removal; Remove Door - Jennair 30" Instrucciones De Instalación

Door Removal

Do not remove the side door spacers until the range is ready
■
to install. Removing the door spacers could allow the door to
shift, damaging the door latch.
Do not lift or move the range by the door handle(s) or control
■
panel.
Prior to installing the range, you will need to remove the oven
■
door(s). Prepare a surface where you will place the door(s).
This surface should be flat and covered with a soft blanket,
or use the corner posts from the packaging material.
A. Oven door hinge in the locked position
B. Oven door hinge in the
unlocked position
Partially close the door to engage the
door latch locks. The door will stop at
this point.

Remove Door

A
Replace the Door
B
■
■
Use two hands to remove and replace
the oven door(s). It may be necessary
to gently shift door from side to side.
A. Slot in the oven frame for the
door hinge lock
To replace the oven door(s), locate the slots in the oven
cavity for the hinge locks and repeat the steps above in
reverse order. Make sure the door closes properly and there
is no interference from the door latch. If necessary, remove
the door and repeat the steps above. If power is connected
to the range, open and close the door to make sure the oven
light comes on and goes off appropriately.
The range is equipped with leveling legs and rollers. Once
the range is removed from the shipping pallet, make sure the
leveling legs are not touching the floor and use the rollers
to move the range into position. Always cover the flooring
surface to avoid damage to the floor. Do not roll the range
directly on the floor.
A
11