Errors; Reparation And Maintenance; Disassembly And Disposal - Hexa Therma CDT/2400 Manual De Usuario

Betriebsanleitung | Manual de usuario | Operating instructions
6.

Errors

Make sure that no contact is loose in case the system does not recognize the sensors.
Make sure that the connection of all four sensor wires is correct. If two of the four wires are
connected incorrectly, the sensor will not work.
If the device does not recognize any sensor, a message will appear on the display. Indicating that
the sensors could not be identified.
Make sure that the power and heating wiring are properly installed.
7.

Reparation and maintenance

If the device is defective, send it to your dealer with a detailed description of the problem.
If the device is dirty, it can be cleaned with a damp cloth when the device is switched off.
8.

Disassembly and disposal

Always disconnect the device from the network before uninstalling.
It is only possible to remove or uninstall the device when it is completely
switched off and disconnected.
Electronics are recyclable materials and do not belong in the household trash!
Please dispose of the product at the end of its service life in accordance with
applicable legal regulations.
Version 1.0 / 2020
HEXA THERMA
42
www.hexatherma.com
info@hexatherma.com