Overmax AD-05 Manual De Usuario página 10

IMPORTANT!
1.
The test result will be set and displayed in per mil (‰). If you
wish to change the alcohol level display format, press the options
select key (3) to switch into the desired format.
2.
The device may emit a long sound when taking the breath sample
and give 0.00. This happens because it is possible to measure
EN
a very low content of other substance in your breath (e.g. bad
smell). By default, if the device detects no alcohol content, it
will emit a long sound and the result will be 0.00.
3.
In some cases the device may display
the conditions of the test are too cold or too hot. Before you
retake the test, wait for a dozen minutes until the sensor inside
the device reaches the room temperature.
4.
The device will switch off automatically after 30 seconds. You
can also switch the breathalyzer off by pressing on/off key (4)
and holding for 3 seconds.
RECOMMENDED WAITING TIME BETWEEN TESTS
•
It is advisable to wait for a few minutes (3-5 minutes) between
every breath test (for low alcohol level).
•
With regard to high alcohol level, please wait for at least 10
minutes before you retake the test. This way you let stubborn
alcohol remains disappear from the sensor. This is also how you
can help keep the proper condition of the sensor and maintain
test result reliability.
2. TEST MEMORY MODE:
To check the total number of breathalyzer tests, please follow the
description below:
•
When counting, press on/off key (4) to display the total number
of tests performed. This number helps you decide about time
for calibration. For more details, see „Calibration".
. It happens when