Inserting The Batteries Into The Remote - JVC RC43160 Guia De Inicio Rapido

1

Inserting the batteries into the remote

The remote may have a screw that secures the battery compartment cover onto the remote control (or this may
be in a separate bag). Then remove the battery compartment cover to reveal the battery compartment. Insert
two 1.5V size AAA batteries. Make sure the (+) and (-) signs match (observing correct polarity). Do not mix old
and new batteries. Replace only with same or equivalent type. Place the cover back on and refit the screw.
Remove the screw that secure the battery compartment cover on the back side of the remote control first. Lift
the cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.
Remove the back cover to reveal the battery compartment. You need to do the followings in order to do that:
• Place the tip of a pen or some other pointed object in the hole above the cover and press it down.
• Then press firmly on the cover and slide in the direction of the arrow.
Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct polarity). Do not
mix old and new batteries. Replace only with same or equivalent type. Place the cover back on.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
rear side of the TV
HDMI connection
rear side or rear-left
side of TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
satellite
dish
aerial /
cable TV
-or-
-or-
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the centre of the
control switch inwards consecutively until the Sources
list is displayed.
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the control
button to display the function options menu and then
press the button consecutively to move the focus to
Source option. Press and hold the button for about 2
seconds to activate this option. The icon colour of the
option changes when activated. Then press the button
once again to display the Sources list. Scroll through
the available sources by pressing the button.
English - 1 -
-or-