Operating Conditions - Oras Ventura 8041 Guía De Instalación Y Mantenimiento

INSTALLATION AND MAINTENANCE GUIDE
General
This Installation and Maintenance Guide introduces the operation, installation and use of the faucet.
Please read the instructions carefully prior to installation and save them for reference where servicing
may be needed. If any fault or malfunction occurs in the faucet, please seek the best possible advice at
an expert HVAC store.
Operation
Oras Ventura is a thermostatic faucet equipped with a flow control handle/diverter (6) that is used to
adjust the waterflow and divert it either to handshower or bath. The temperature adjustment handle
(8) is set at 38°C. To raise the water temperature above 38°C, press the button in the handle and
simultaneously turn it to the red. For colder water, turn the handle to the blue.
Places of use
Oras Ventura faucet is designed for shower and bath use.

Operating conditions

Faucets and accessories are not suitable for hot steam rooms (max. temperature +65°C).
Note! Installation of the faucet requires concealed inlet pipes.
Installation (figure 1)
The distance between the hot and cold water inlets at the back of Oras Ventura is 150 mm. Hot water is
connected to the left and cold water to the right. The inlet pipes must be equipped with stop valves that
are installed in the pipes ahead of the faucet. Inlet water supplies must not be cross-connected!
– Attach the eccentric unions (1) to the wall so that they are in horizontal position and protrude
10-20 mm from the installation body (2).
– The locking nuts (3) of the installation body (2) must be sealed to the eccentric unions with suitable
sealing material.
– Lubricate the O-rings (3a) of the locking nuts (3) with O-ring grease.
– Place the faucet over the installation body (2) and attach it with two hexagonal screws (5)
using a 5 mm Allen key.
Temperature adjustment (factory default +38°C) (figure 2)
– Grip the flow control handle (6) firmly and pull it off.
– Lift off the temperature limiter (7).
– Open the water inlet by using the flow control handle (6).
– Adjust water temperature as required (e.g. 38°C) by turning the temperature adjustment handle (8).
– Pull off the temperature adjustment handle (8).
– Replace the temperature adjustment handle so that the lever points to the user as shown in the
figure.
– Replace the temperature limiter (7) so that the marking (10) points to the user.
– Close the water inlet by using the flow control handle (6).
– Replace the flow control handle.
Cleaning the litter filters (figures 1 and 3)
– Close the water inlet to the faucet.
– Undo the hexagonal screws (5) under the faucet and hold up the faucet at the same time.
Figure 3
– Clean the filters (12) inside the inlet unions and then replace them.
– Attach the faucet to the wall with hexagonal screws (5).
– Open the water inlet to the faucet and check that the faucet operates correctly.
9
GB