DIVERSITECH CP-22LP-P Manual Del Usuario página 2

Introduction
Safety Information
Please read, understand, and follow all safety instructions. Failure to follow
instructions may result in property damage, serious injury, or death.
DANGER
Always disconnect power prior to moving, adjusting, or servicing pump or
attached systems. DO NOT use this pump in the presence of spraying or
standing water. Failure to do so could result in a fatal electric shock.
WARNING: Fire and Explosion Hazard
DO NOT use this pump to move flammable or explosive liquids. DO NOT use this
pump in explosive or flammable environments.
Ensure that pump is mounted away from heat exchanger or wiring. If you are
unsure of any items in this manual, please consult a professional and DO NOT
attempt to install this product.
CAUTION: Flood Risk
Personal injury or property damage can result from an inoperative pump. If a
flood has occurred, DO NOT walk in wet area until all power has been turned
off. Check with local electric company or a qualified electrician before
disconnecting any electrical service prior to pump removal.
WARNING
Pump must be properly wired to condensate producing appliance control
board in order to shut off appliance in alarm (high water) conditions.
Supply voltage and frequency must match what is shown on pump nameplate.
Source voltages lower than the rated supply can reduce performance and
cause pump to overheat.
Pump must be level and should be mounted to, or placed on, a solid surface or
floor.
DO NOT cover pump air vents. Pump is air cooled. DO NOT cover vent holes
located on top or sides of the pump housing. Pump may be operated
continuously as long as air vents are not covered.
Pump should be installed indoors. The chosen location should be clean and
dry.
This pump is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
pump by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the pump.
Temperature Rating (Not tested for hot water)
• Continuous duty 140˚F
• Max inlet temperature 160˚F
• Not suitable for contact with steam or gasses that exceed 160˚F
This pump should be installed by HVAC/R trained service professionals.
2