Input Configuration: Daisy Chain Speakers; Specifications - Cerwin-Vega TS-42 Manual Del Usario

4. INPUT CONFIGURATION: DAISY CHAINING SPEAKERS
Since all Cerwin-Vega! Folded Horns are equipped with a pair of Speakons connectors (that are parallel inputs);
it is possible to daisy-chain speakers by connecting the output of the powered amplifier to one input, then daisy
chaining to a second speaker.
Since each folded horn is an 8 ohm load, daisy chaining two folded horns would provide a 4 ohm load.
Caution If you daisy chain two folded horns make sure that you double your amplifier power and use an amplifier
that will handle a 4 ohm load. Because of the current limitations of the Neutrik Speakon connectors it is not
recommended to daisy chain more than two TS-42 folded horns.
5.

SPECIFICATIONS

Frequency Response
Sensitivity @ 1w / 1 Meter
Power Capacity
Recommend Amplifier Power
Maximum SPL
Input Connectors
Voice Coil Diameter
Nominal Impedance
Weight
Dimensions (H x W x D)
Cerwin-Vega! TS-42 Folded Horn
Cerwin-Vega! TS-42 Folded Horn
3
(-3 dB) 35 Hz – 215 Hz
(-10 dB) 33 Hz – 230 Hz
108 dB
1000 w (RMS), 2000 w (Peak)
1500 w - 2000 w @ 8 ohms
144 dB
(2) Neutrik Speakon
4"
8 ohms
228.5 lbs
103.6 kg
42.5" x 24" x 45.3"
108 cm x 61.07 cm x 115 cm