Installing The Switch In An Equipment Rack - Avaya VSP 7000 Serie Manual Del Usuario

English
Note:
VSP 7000 series switches do not have a power switch. Ensure that your DC power source
is off when connecting DC power cables to the back of the switch power supply. Verify all
terminal connections, then connect the DC power cables to your DC power source. When
you connect the DC power supply to a suitable DC power source, the switch powers up
immediately.
You must prepare the cables by stripping insulation from the end of the cable approximately
0.81 inch (2.1 cm) before you fasten each cable to a power supply terminal. The following
figure shows the DC power supply terminals and DC power supply status LEDs.
Figure 6: DC power supply terminals

Installing the switch in an equipment rack

Before you begin
24 Avaya Virtual Services Platform 7000 Series Regulatory Information for VSP 7024XLS
Comments? infodev@avaya.com
June 2012