Troubleshooting; Technical Specification; Electrical Wiring - Buffalo CD406 Manual De Instrucciones

Troubleshooting

Fault
The unit is not working
NOTE: Jug / Blades are not covered by manufacturers warranty

Technical Specification

Model Voltage Power
CD406 230v 50hz 1500W

Electrical Wiring

This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
•
Live wire (coloured brown) to terminal marked L
•
Neutral wire (coloured blue) to terminal marked N
•
Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit. If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they
must be readily accessible.
Telephone Helpline: 0845 146 2887 (United Kingdom)
Probable Cause
The Unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Unit has overheated
Jug incorrectly located on body of
appliance
Jug
Current
Capacity
6.5A 2.0L
Check the unit is plugged in
correctly and switched on
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check Power Supply
Call BUFFALO agent or qualified
technician
Allow to cool. When cool press
reset switch located on base
Relocate Jug
Dimensions Weight
h x w x d mm (kg)
490 x 200 x 230 6
Action