Important; Operating Your Nebulizer; After Every Use - MABIS MargoMoo Guía Detallada

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2) Remove the contents (Nebulizer, mouth-
piece and air tube) from the tote carrying
bag.
3) Gently twist and pull straight up on the lid
of the Nebulizer to separate into two parts
(medicine cup and cover).
4) Make sure that the purple jet
is properly installed inside the
medicine cup. (The stem
inside the medicine cup
inserts into the tube of the
purple jet), Fig. 4.
5) Add the prescribed
amount of medication to
the medication cup, Fig. 5.
6) Reassemble the Nebulizer
by carefully twisting the
medicine cup and cover
together. Make sure that
the two parts fit securely.

Operating Your Nebulizer

Note: The
Nebulizer is
operable at up to a
45
angle.
o
1) Attach one end
of the air tube
connector to the
air stem, Fig. 6.
2) Carefully attach
the opposite end
of the air tubing
connector to the
stem at the base
of the Nebulizer,
Fig. 7.
3) Attach the
angled
mouthpiece or
mask to the top of the
Nebulizer, Fig. 8.
If using the optional tee adapter set,
a) Attach the tee adapter to the top
of the Nebulizer,
b) Connect one end of the tee
adapter to the straight mouthpiece
and the other to the extension
tube.
Note: The tee adapter is not needed
when using a mask.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
4) Check that the POWER switch is in the
"off" position. Plug the power cord into a
main outlet.
5) Press the POWER switch to the "on"
position.
6) Start your treatment according to your
physicianʼs or therapistʼs instructions.
Note: The
crescent-shaped
groove on the side
of the compressor
can be used to sup-
port the nebulizer
during treatments,
Fig. 9.
7) Once the treatment is complete, press the
POWER switch to the "off" position and
unplug the power cord from the
outlet.

IMPORTANT!

The Compressor will automatically shut off if
it becomes overheated. If/when this hap-
pens, immediately:
1) Press the POWER switch to the "off"
position.
2) Unplug the power cord from the outlet.
3) Allow the motor to cool for 30 minutes.
Before restarting the unit, make sure that the
air vents are not obstructed.

After Every Use

1) Unplug the unit from the power source.
2) Allow the unit to completely cool.
3) Carefully detach the air tubing from the
Nebulizer and pour out any remaining
medication.
4) Follow the cleaning procedures provided
in this guidebook.
5
Fig. 9

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

40-269-000

Tabla de contenido