Pelonis HO-158E Manual Del Usuario página 2

UNPACKING AND SET-UP INSTRUCTIONS
Unpack your heater and remove the wheel assemblies from the package. Refer to Fig. 1
below:
1. Make sure the heater is unplugged and
in the "OFF" position.
2. TURN THE HEATER UPSIDE DOWN.
3. Position the wheel base assemblies
between the end fins as shown.
4. Insert each U-shape screw into the
holes of each wheel holding plate.
5. Insert the butterfly nuts and screw
them tightly.
6. Turn the heater upright.
Your heater is now ready for use.
CAUTION: Risk of fire – Do not operate heater without wheel assemblies attached.
Operate heater in upright position only (wheels on bottom, controls on top). Any other
position could create a hazardous situation.
Safety Cover
Control Panel
Front Handle
IMPORTANT!
Your heater is equipped with a polarized alternating current line plug (a plug having one blade
wider than the other). This plug will fit into the power outlet only one way. This is a safety
feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact your electrician to replace your outlet. DO NOT defeat the
safety purpose of the polarized plug.
Fig. 1 - Upside down view
U-shape
Wheel
screw
holding
plate
Rear Handle
(behind unit)
8 Heating
Elements
Cord Storage
Caster
Wheels
OPERATING INSTRUCTIONS
Place the heater on a firm level surface free from obstructions, and at least 3 ft. away
from any wall and any other objects such as furniture, curtains, plants or combustible
material.
To program the functions of your electronic oil filled heater, refer to the control panel in
Fig. 2.
Fig. 2 - Control Panel View
•
Press the "POWER" button to turn the heater ON.
• Select the power you desire by pressing the LO/MED/HI button. On LO, the heater
operates at 600W. On MED, the heater operates at 900W. On HI, the heater
operates at 1500W.
Press the "TEMP SETTING" button to select the desired temperature. There are 7
positions from MIN to MAX.