Chauvet DJ WMS Guía De Referencia Rápida página 2

EN
The WMS (Wireless Motion Sensor) allows you to trigger compatible foggers with motion
activation. This consists of the transmitter with
of up to 4 fog machines independently. More may be run if addressed simultaneously. See the
instructions below to set up your fogger to operate with the WMS.
Instructions
Mounting Points
Wireless Motion
Sensor (WMS)
Transmitter
Duration
Battery Compartment
(E-23A 12v)
5200 N.W. 108th Ave., Sunrise, FL 33351 U.S.A. (800) 762-1084 – (954) 577-4455 FAX (954) 929-5560
Wireless Motion Sensor
1. Plug the wireless receiver into the 5-pin port labeled Wireless Controller
on the fog machine.
2. Set the 4 dipswitches on the WMS transmitter and receiver to the same
channel. Both the WMS and receiver dipswitches must match in order for
the 2 to communicate. See the configuration below for setting the WMS to
operate with the receiver.
Channel
CH1
CH2
CH3
CH4
3. Adjust the knob marked Duration to set the desired lenth of time the fog
machine should output.
4. Adjust the knob marked Sensitivity to adjust how much motion is needed
to trigger the sensor.
5. Repeat steps 3 and 4 until desired duration and sensitivity are acheived.
Note: The duration of continuous fog output is based on the capability of
the fog machine.
Knob
built-in delay time and sensitivity knobs for control
1 = On; 2-4 = Off
2 = On; 1, 3, 4 = Off
3 = On; 1, 2, 4 = Off
4 = On; 1, 2, 3 = Off
LED
Indicator
(ready)
Power
Sensitivity
Knob
Dipswitches
Dipswitches
LED indicator
(heating)
Wireless
Receiver
www.chauvetlighting.com