Block Diagrams; General Notes - Laney RB2 Manual Del Usario

INPUTS
NORMAL
GAIN
HI
PAD
INPUTS
NORMAL
GAIN
HI
PAD

General Notes

Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc.
BEFORE turning on your Bass Amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers. By turning on your Bass Amplifier LAST and making sure its Volume control is set to minimum any transients from
other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly
when turning off your system always turn down the Volume control on your Bass Amplifier and then turn off its power before
turning off other equipment.
Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the
amplifier load and could cause damage to your amplifier system.
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
ON ACTIVE
COMPRESSOR
EQ SECTION
SECTION
ON ACTIVE
COMPRESSOR
EQ SECTION
SECTION
Aux In (3.5mm)
D.I.
VOLUME
POWER
AMP
Aux In (3.5mm)
D.I.
FX LOOP
SEND RETURN
VOLUME
This loop is a series type so all
your signal will go through your
FX unit.

BLOCK DIAGRAMS

Headphones (3.5)
LOUDSPEAKER
Headphones (3.5)
POWER
LOUDSPEAKER
AMP
13