Horton Polar-Extreme S Instrucciones De Servicio página 14

3. Apply O-ring lubricant to the outside O-rings
of the new Cartridge and install the new
Cartridge Assembly into the Journal Bracket;
then, reinstall the Retaining Rings to hold the
new Cartridge Assembly in tight.
The Retaining Ring must be fully seated in the
retaining ring groove to keep the Cartridge
Assembly from moving. Also, the Retaining Ring
is beveled. The curved side must be installed
facing the Cartridge.
4. Clean both the Carbon Tip of the Cartridge
Assembly and also the Face Seal of the Air
Chamber Assembly to make sure they are free
of lubricants and dust.
Retaining Ring
O-Rings
Step 3
Retaining
Ring
Step 3
14
The curve faces the
Cartridge
Cartridge
Assembly
Step 4
Carbon Tip