Important Safeguards - Kalorik SB 36580 Manual Del Usuario

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS
2. Check that your mains voltage corresponds to that stated on the
rating plate of the appliance before using the appliance.
3. To protect against electrical shock do not immerse cord, plug, or
the unit with motor in water or other liquid.
4. Close supervision is necessary when the appliance is used by or
near children.
5. Unplug from outlet when not in use and before putting on or
taking off parts or before cleaning.
6. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the Kalorik service facility for
examination, repair, or adjustment.
7. The use of accessory attachments or parts not recommended by
the appliance manufacturer may cause fire, electric shock, or
injuries.
8. Do not use outdoors.
9. Place on the dry floor only. Do not place or store appliance
where it can fall or be pulled in a tub of sink. Always place on a
stable, flat surface.
10. To disconnect, turn the appliance to off, and then remove the
plug from the wall outlet.
11. Do not unplug by pulling on the cord. To unplug, grasp the plug,
not the cord.
12. Do not pull or carry by the cord or use the cord as a handle.
13. Do not use the appliance for other than intended use.
14. This kind of appliance cannot function continuously; it is not a
professional type of appliance. It is necessary to make temporary
stops. Check the section "Important information" in the
instruction manual.
15. Avoid contact with moving parts, unless for a shoe.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
2
Assembly page 2/16
special instruction from Team
Print only
USK SB 36580 - 110622