Cleaning And Maintenance - URSUS TROTTER UT-ECKART2 Manual De Usuario Y Letra De Garantía

Control panel: (see below)
For the first use
As there is manufacturing residue or oil remained in the
toaster or heat element, usually it will emit the odor for
the first use. It is normal and will not occur after several
times use, for the first use it is suggested operating
according to the below steps, except without bread, then
let the toaster cool down and begin toasting the first
slice.
OPERATION
1. Insert regular bread slice into the bread slot, which can
be inserted with two slices at most each time.
Note: Make sure the crumb tray is completely positioned
in place before use.
2. Plug the power cord into the outlet.
3. Turn color control knob to your desired color. There
are 7 color levels, the lowest "1" is for white and the
highest "7" is for dark. The middle "4" can toast the bread
to golden color.
Note: 1). Toasting color for one slice is darker than that for
two bread slices at the same level.
2). If toasting continuously, toasting color for the latter
bread is darker than that
for the anterior bread at the same level.
4. Lower carriage handle down vertically until it is latched
in place, and the appliance will begin toasting at once.
Note: Carriage handle can be latched only when the unit
is plugged in.
5. Once the bread has been toasted to the preset color,
the carriage handle will be automatically pop up. Also you
can uplift the carriage handle a little to remove the bread
readily.
Note: During toasting, you may also observe the toasting
color. If it is satisfactory, you can press the Cancel button
to cancel the operation at any time, but never lift carriage
handle to cancel toasting.
CAUTION
1. If toaster starts to smoke, press Cancel button to stop
toasting immediately.
2. Remove all protective wrappings prior to placing bread
slice into toaster.
3. Avoid toasting the food with extremely runny
ingredients such as butter.
4. Never attempt to remove bread jammed in the slots
without unplugging the toaster from the electrical outlet
first, Be sure not to damage the internal mechanism or
heating elements when removing bread.
5. In order to achieve uniform color we recommend that
you should wait minimum 30s between each toasting so
that color control can reset automatically.
5. The bread slot is only applicable for toasting regular
bread.

Cleaning and maintenance

1. Before cleaning, unplug from the appliance and let the
appliance cool down completely 2. Wipe the outside with
soft dry cloth, never use metal polish.
3. Pull out crumb tray at bottom of toaster and empty it.
If toaster is used frequently, accumulated bread crumbs
should be removed at least once a week. Make sure the
crumb tray is completely closed before using the toaster
again.
4. When not in use or storage, the power cord may be
twisted under the bottom of toaster.
ENVIRONMENT FRIENDLY DISPOSAL
You can help protect the environment!
Please remember to respect the local regulations:
hand in the non-working electrical equipments to
an appropriate waste disposal center.