Before First Use; Water Test; Using Your Glass Kettle; Boiling Water - cosori CO171-GK Manual Del Usuario

EN

BEFORE FIRST USE

Water Test

CAUTION!
Do not remove the glass kettle from
the package if it is broken. Contact
Customer Support immediately to
replace your kettle.
This process is meant to test if the kettle is
working properly. Do not drink the water
that is boiled during this initial test.
1.
Remove all parts from the package and
carefully inspect each part.
2.
Completely unravel the power cable,
then place the power base on a flat,
level surface.
3. Press the Lid Release Button to open
Figure 1.1
the lid. [ ]
4. Fill the kettle with water to the "MAX"
line, then close the lid. Place the kettle
onto the power base and connect the
plug to a powered electrical outlet.
Figure 1.2
[ ]
5. Press the On/Off Switch to turn on the
kettle. The blue indicator light will turn
Figure 1.3
on. [ ]
6. The kettle will automatically turn off
once it has finished boiling the water.
Allow it to cool for at least 5 minutes,
then pour out the water.
8
Figure 1.1
Figure 1.2
Figure 1.3

USING YOUR GLASS KETTLE

Boiling Water

Do not attempt to boil other liquids in this
kettle. This kettle is only suitable for boiling
water.
1. Press the Lid Release Button to open
the lid.
2. Fill the kettle to the desired level.
Remember to not fill above the "MAX"
Figure 2.1
line. [ ]
3. Close the lid and place the kettle onto
the power base. Connect the plug to a
Figure 2.2
powered electrical outlet. [
4. Press the On/Off Switch to turn on the
kettle. The blue indicator light will turn
on. The kettle will automatically turn off
once it has finished boiling the water.
Figure 2.3
[ ]
Note:
• Remember to fill the kettle with water to at
least the "0.50L" line. Failure to do so may
cause the heating plate to overheat.
• You can stop the heating process by flipping
the On/Off Switch back up while the kettle
is operating.
• This kettle has a dry-run safety feature. If
there is no water inside the kettle during
operation, it will automatically turn off to
prevent the heating plate from overheating.
• If the kettle overheats, fill it with cold water
and wait for 2 minutes before resuming use.
Figure 2.1
]
Figure 2.2
Figure 2.3
EN
9